![]() Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) PID hash table entries: 256 (order: 8, 1024 bytes)ĭentry cache hash table entries: 8192 (order: 3, 32768 bytes) No local APIC present or hardware disabled Kernel command line: block2mtd.block2mtd=/dev/hda2,65536,rootfs root=/dev/mtdbloĬk0 rootfstype=jffs2 init=/etc/preinit noinitrd console=tty0 console=ttyS0,38400n8 reboot=bios e.g.ĭefault /etc/config/network configuration # Copyright (C) 2006 īr-lan: port 1(eth0) entering disabled stateĮth0: Setting full-duplex based on negotiated link capability.īr-lan: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature.īr-lan: port 1(eth0) entering learning stateīr-lan: topology change detected, propagatingīr-lan: port 1(eth0) entering forwarding stateīoot log Linux version 2.6.25.17 (gcc version 4.1.2) #1 Sun Feb 15 02:46:īIOS-e801: 0000000000000000 - 000000000009f000 (usable)īIOS-e801: 0000000000100000 - 0000000004000000 (usable)Īllocating PCI resources starting at 10000000 (gap: 04000000:fc000000)īuilt 1 zonelists in Zone order, mobility grouping on. With the kmod-leds-wrap package installed, it is possible to configure the LEDs on the Wrap. Option 'key' 'dnsdy83rw78erjhsdfnjdfsnHJHJHdh383838.a long secret. Note that the type for wadwifi in the configuration file is 'atheros', whereas the type for ath5k is 'mac80211'. This setup uses the madwifi kernel module. ![]() The driver is close to being fully functional, but the interface didn't come up automatically. VERY IMPORTANT: Using the ath5k driver failed to achieve a positive outcome (a lot of wasted time). This is just one long line copied from ~/.ssh/id_dsa.pubĬonfigure the wireless interface for WPA2 with a PSK. ![]() Login as root, using the password set above Using the LuCI web configuration to customise Set the root password using the console: # passwd Using the console, reconfigure the network settings from their defaults so that the 'lan' interface is operational in the local environment: # Copyright (C) 2006 Īpply the changes to the lan network configuration: # ifup lan Use minicom as a console on the serial port at 38400,8,n,1. Write the image to a 64MByte compact flash card, and boot. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |